Sp-controls PixiePlus Bedienungsanleitung PDF herunterladen (Seite 9)

IV. PixiePlus Installation cont’d

3. Wire Controller

Connect the 3-conductor cable to the captive screw connector on the back of the

PixiePlus. Be sure that the wires match the connections on the cable assembly

block end - the PixiePlus uses crossover wiring.

Verify the captive screw connectors are fully open before inserting the wires.

It is possible to physically anchor the wires without making a solid electrical

connection if they are turned the wrong way.

BUS

+6V

GND

BUS

+6V

GND

Wire landing must match

landing on cable assembly

block at the display device

side (see pg. 4).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

Keine Kommentare

Sp-controls PixiePlus Bedienungsanleitung Seite 9